• Pharmacotherapy · Nov 2019

    Pharmacokinetics and Pharmacodynamics of Extended-Infusion Cefepime in Critically Ill Patients Receiving Continuous Renal Replacement Therapy: A Prospective, Open-Label Study.

    • Carolyn D Philpott, Christopher A Droege, Molly E Droege, Daniel P Healy, Joshua D Courter, Neil E Ernst, Nicole J Harger, Madeline J Foertsch, Jessica B Winter, Kristen E Carter, Suzanne L Van Fleet, Krishna Athota, and Eric W Mueller.
    • UC Health, University of Cincinnati Medical Center, Cincinnati, Ohio.
    • Pharmacotherapy. 2019 Nov 1; 39 (11): 1066-1076.

    Study ObjectiveTo evaluate extended-infusion (EI) cefepime pharmacokinetics (PK) and pharmacodynamic target attainment in critically ill patients receiving continuous venovenous hemofiltration (CVVH) or continuous venovenous hemodialysis (CVVHD).DesignProspective, open-label, PK study.SettingIntensive care units at a large, academic, tertiary-care medical center.PatientsTen critically ill adults who were receiving cefepime 2 g intravenously every 8 hours as a 4-hour infusion while receiving CVVH (eight patients) or CVVHD (two patients).InterventionTwo sets of five serum cefepime concentrations were collected for each patient to assess pharmacokinetics before and during presumed steady state. Concurrent serum and CRRT effluent samples were collected at hours 1, 2, 3, 4, and 8 after the first cefepime dose and after either the fourth, fifth, or sixth (steady-state) cefepime doses.Measurements And Main ResultsReversed-phase high-performance liquid chromatography was used to determine free cefepime concentrations. PK analyses included CRRT clearance, half-life, and sieving coefficient or saturation coefficient. Cefepime peak (4 hrs) concentrations, trough (8 hrs) concentrations (Cmin ), and minimum inhibitory concentration breakpoint of 8 µg/ml for the pathogen (MIC8 ) were used to evaluate attainment of pharmacodynamic targets: 100% of the dosing interval that free drug remains above MIC8 (100% fT > MIC8 ), 100% fT > 4 × MIC8 (optimal), percentage of time fT > 4 × MIC8 (%fT > 4 × MIC8 ) at steady state, and ratio of Cmin to MIC8 (fCmin /MIC8 ). Total CRRT effluent flow rate was a mean ± SD of 30.1 ± 5.4 ml/kg/hr, CRRT clearance was 39.6 ± 9.9 ml/min, and half-life was 5.3 ± 1.7 hours. Sieving coefficient or saturation coefficient were 0.83 ± 0.13 and 0.69 ± 0.22, respectively. First and steady-state dose Cmin were 23.4 ± 10.1 µg/ml and 45.2 ± 14.6 µg/ml, respectively. All patients achieved 100% fT > MIC8 on first and steady-state doses. First and steady-state dose 100% fT > 4 × MIC8 were achieved in 22% (2/9 patients) and 87.5% (7/8 patients) of patients, respectively. The mean %fT > 4 × MIC8 at steady state was 97.5%. The fCmin /MIC8 was 2.92 ± 1.26 for the first dose and 5.65 ± 1.83 at steady state.ConclusionExtended-infusion cefepime dosing in critically ill patients receiving CRRT successfully attained 100% fT > MIC8 in all patients and an appropriate fCmin /MIC8 for both first and steady-state doses. All but one patient achieved 100% fT > 4 × MIC8 at steady state. No significant differences were observed in PK properties between first and steady-state doses among or between patients. It may be reasonable to initiate an empiric or definitive regimen of EI cefepime in critically ill patients receiving concurrent CRRT who are at risk for resistant organisms. Further research is needed to identify the optimal dosing regimen of EI cefepime in this patient population.© 2019 Pharmacotherapy Publications, Inc.

      Pubmed     Full text   Copy Citation     Plaintext  

      Add institutional full text...

    Notes

     
    Knowledge, pearl, summary or comment to share?
    300 characters remaining
    help        
    You can also include formatting, links, images and footnotes in your notes
    • Simple formatting can be added to notes, such as *italics*, _underline_ or **bold**.
    • Superscript can be denoted by <sup>text</sup> and subscript <sub>text</sub>.
    • Numbered or bulleted lists can be created using either numbered lines 1. 2. 3., hyphens - or asterisks *.
    • Links can be included with: [my link to pubmed](http://pubmed.com)
    • Images can be included with: ![alt text](https://bestmedicaljournal.com/study_graph.jpg "Image Title Text")
    • For footnotes use [^1](This is a footnote.) inline.
    • Or use an inline reference [^1] to refer to a longer footnote elseweher in the document [^1]: This is a long footnote..

    hide…