Journal of biomechanics
-
Journal of biomechanics · Dec 2005
Controlled Clinical TrialLength-tension properties of ankle muscles in chronic human spinal cord injury.
Contracture, or loss of range of motion (ROM) of a joint, is a common clinical problem in individuals with spinal cord injury (SCI). In order to measure the possible contribution of changes in muscle length to the loss of ankle ROM, the active force vs. angle curves for the tibialis anterior (TA) and gastrocnemiussoleus (GS) were measured in 20 participants, 10 with SCI, and 10 gender and age matched, neurologically intact (NI) individuals. Electrical stimuli were applied to the TA and GS motor nerves at incremented angles of the entire ROM of the ankle and the resulting ankle and knee torques were measured using a multi-axis load cell. ⋯ Differences in the passive ROM were consistent with the force-angle changes. The ROM in the dorsiflexion direction was significantly smaller in SCI subjects compared to NI controls (p<0.05) while the plantar flexion ROM was not significantly different (p=0.114). Based upon these results, we concluded that muscle shortening is an important component of contracture in SCI.
-
Journal of biomechanics · Nov 2005
A finite element model for analyzing shear wave propagation observed in magnetic resonance elastography.
Magnetic resonance elastography (MRE) is a novel non-invasive approach to determine material stiffness by using a conventional magnetic resonance imaging (MRI) system incorporated with an oscillating motion-sensitizing gradient to detect nodal displacements produced by a shear excitation wave. The effects of material properties, excitation frequency, boundary conditions, and applied tension on shear wavelength measurement must be examined before MRE can become a useful diagnostic tool. We propose finite element (FE) modeling as a robust method to systematically study the effects of these parameters. ⋯ The effects of material stiffness, density, and excitation frequency on propagating shear wavelength were examined individually. The effect of the boundary conditions on shear wavelength was also demonstrated. Results of shear wavelength from MRE measurement were compared with the results of FE model, which showed good agreement between the methods.
-
Journal of biomechanics · Jul 2005
Clinical TrialMechanical energy and effective foot mass during impact loading of walking and running.
The human heel pad is considered an important structure for attenuation of the transient force caused by heel-strike. Although the mechanical properties of heel pads are relatively well understood, the mechanical energy (Etot) absorbed by the heel pad during the impact phase has never been documented directly because data on the effective foot mass (Meff) was previously unavailable during normal forward locomotion. In this study, we use the impulse-momentum method (IMM) for calculating Meff from moving subjects. ⋯ At the instant prior to heel strike, Etot ranges from 0.24 to 3.99 J. The combination of video and forceplate data used in this study allows analyses of Etot and Etot as a function of heel-strike kinematics during normal locomotion. Relationship between Meff and knee angle provides insights into how changes in posture moderate impact transients at different gaits.
-
Journal of biomechanics · Jul 2005
The contribution of contractile pre-activation to loss of function after a single lengthening contraction.
Some muscle injuries are the result of a single lengthening contraction. Our goal was to evaluate the contributions of angular velocity, arc of motion, and timing of contractile activation relative to the onset of joint motion in an animal model of muscle injury using a single lengthening contraction. ⋯ The data indicated that the duration of an isometric contraction prior to a single lengthening contraction determined the extent of muscle injury irrespective of two different angular velocities.
-
Journal of biomechanics · May 2005
Comparative StudyHigh rate shear strain of three-dimensional neural cell cultures: a new in vitro traumatic brain injury model.
The fidelity of cell culture simulations of traumatic brain injury (TBI) that yield tolerance and mechanistic information relies on both the cellular models and mechanical insult parameters. We have designed and characterized an electro-mechanical cell shearing device in order to produce a controlled high strain rate injury (up to 0.50 strain, 30 s(-1) strain rate) that deforms three-dimensional (3-D) neural cultures (neurons or astrocytes in an extracellular matrix scaffold). Theoretical analysis revealed that these parameters generate a heterogeneous 3-D strain field throughout the cultures that is dependent on initial cell orientation within the matrix, resulting in various combinations of normal and shear strain. ⋯ In addition, cell death was demonstrated in rat cortical astrocytes and neurons in response to high rate, high magnitude shear strain. Furthermore, cell response within the 3-D neuronal cultures depended on orientation, with higher predicted shear strain correlating with an increased loss of neurites, indicating that culture configuration may be an important factor in the mechanical, and hence cellular, response to traumatic insults. Collectively, these results suggest that differential responses exist within a 3-D culture subjected to mechanical insult, perhaps mimicking the in vivo environment, and that this new model can be used to investigate the complex cellular mechanisms associated with TBI.