European spine journal : official publication of the European Spine Society, the European Spinal Deformity Society, and the European Section of the Cervical Spine Research Society
-
Coronal decompensation following correction of adolescent idiopathic scoliosis (AIS) has been reported to be due to the Cotrel-Dubousset rod derotation maneuver, or to a hypercorrection of the main thoracic curve. The treatment of such decompensation consists classically in observation, bracing, or extension of the instrumentation in the lumbar spine for a King 2 curve, or in the upper thoracic spine for a King 5 curve. As the postoperative decompensation is related to a hypercorrection of the main thoracic curve (relative to the compensatory curve), we hypothesized that if we were to "let the spine go" to some of its initial deformity, the balance of the patient would be improved. ⋯ These results were stable at 1-year follow-up. In the event of a persisting imbalance, we recommend, in selected cases, letting the spine go by removing all the implants located between the end vertebrae of the main thoracic curve. This adjustment or fine-tuning of the instrumentation should be done before the fusion takes place, and is best achieved with an instrumentation in which the hooks can be easily removed from the rod.
-
Comparative Study
Titanium-alloy enhances bone-pedicle screw fixation: mechanical and histomorphometrical results of titanium-alloy versus stainless steel.
Several types of pedicle screw systems have been utilized to augment lumbar spine fusion. The majority of these systems are made of stainless steel (Ss), but titanium-alloy (Ti-alloy) devices have recently been available on the market. Ti-alloy implants have several potential advantages over Ss ones. ⋯ Bone ongrowth on Ti was increased by 33% compared with Ss (P < 0.04), whereas no differences in bone volume around the screws were shown. Mechanical binding at the bone-screw interface was significantly greater for Ti pedicle screws than for Ss, which was explained by the fact that Ti screws had a superior bone ongrowth. There was no correlation between the screw removal torque and the pull-out strength, which indicates that the peripheral bone structure around the screw was unaffected by the choice of metal.
-
Multicenter Study Clinical Trial
Posterior endoscopic discectomy (and other procedures).
Percutaneous approaches to lumbar discectomy were somewhat controversial, because of their limited indications. They have not proven to be as effective as standard open lumbar disc surgery, because of longer operating times and some technical problems in addressing all the different aspects of lumbar disc herniations. ⋯ MED, and METR'x which evolved from it,. allow the surgeon to address not only contained lumbar disc herniations, but also free-fragment disc pathology and symptomatic lateral recess stenosis secondary to bony hypertrophy. The surgical technique is summarized and some preliminary clinical results of a prospective multicenter study with 13 months' mean follow-up are presented.
-
Comparative Study
Lumbar disc high-intensity zone: the value and significance of provocative discography in the determination of the discogenic pain source.
Disagreement still exists in the literature as to the significance of the high-intensity zone (HIZ) demonstrated on magnetic resonance imaging (MRI) as a potential pain indicator in patients with low back pain. A prospective blind study was therefore conducted to evaluate the lumbar disc high-intensity zone with the pain provocation response of lumbar discography. Consecutive patients with low back pain unresponsive to conservative treatment and being considered for spinal fusion were subjected to MRI followed by lumbar discography as a pre-operative assessment. ⋯ The sensitivity, specificity and positive predictive value for pain reproduction were high, at 81%, 79% and 87% respectively. The nature of the HIZ remains unknown, but it may represent an area of secondary inflammation as a result of an annular tear. We conclude from our study that the lumbar disc HIZ observed on MRI in patients with low back pain is likely to represent painful internal disc disruption.
-
The most readily available source for autologous bone graft used in spinal fusion (the gold standard) is the iliac crest. However, the open surgical approach for harvesting corticocancellous iliac bone is associated with a marked increase in morbidity. This study suggests two alternatives to the traditional open harvesting procedure. ⋯ Regional bone graft harvest in anterior spine surgery is suggested to be anatomically safe and biomechanically acceptable. Any of the three filler materials can restore the vertebral body's mechanical strength, but the filler's long-term resorption/remodeling or osteointegration behavior is unknown. The minimally invasive bone graft harvester is a novel tool, which performed satisfactorily under laboratory conditions, but clinical results are still missing.