The spine journal : official journal of the North American Spine Society
-
The transforaminal lumbar interbody fusion (TLIF) technique supplements posterior instrumented lumbar spine fusion and has been tested with different types of screw fixation for stabilization. Transforaminal lumbar interbody fusion is usually placed through a unilateral foraminal approach after unilateral facetectomy, although extraforaminal entry allows the facet to be spared. ⋯ These results suggest that fixation at L4-L5 with TFPS is a promising alternative to PSR, with or without TLIF. A TLIF device was less stable than the native disc with both methods of instrumentation presumably because of a fulcrum effect from a relatively small footplate. Additional interbody support may be considered for improved biomechanics with TLIF.
-
Observational Study
Early outcomes and complications of posterior vertebral column resection.
Hyperkyphosis confers a significant risk for neurologic deterioration as well as compromised cardiopulmonary function. Posterior vertebral column resection (PVCR) is a challenging but effective technique for spinal cord decompression and deformity correction that even under the setting of limited resources can be performed to reduce the technical difficulties, the operating time, and possibly the complications of the traditional two-staged vertebral column resection (VCR). ⋯ Posterior vertebral column resection was successfully undertaken for the management of thoracic and thoracolumbar hyperkyphosis, demonstrating improvements in overall kyphosis and clinical outcome. Neuromonitoring provided the required safety to perform these challenging complex spine deformity procedures.
-
Revision surgery for pseudarthrosis after a lumbar spinal fusion has unpredictable functional results. ⋯ The clinical outcomes after revision surgery for pseudarthrosis are worse in patients with DDD compared with spondylolisthesis despite successful repair of nonunion. Risks and benefits should be well discussed with the patients before deciding on surgical treatment for the management of pseudarthrosis, especially in patients with previous short-segment fusions done for DDD.
-
Recent reports have suggested that excessive motion of the lumbar spine might be associated with low back pain and accelerated disc degeneration and may negatively influence the outcome of posterior lumbar interbody fusion (PLIF) surgery. These findings suggest that generalized joint laxity (GJL) might be a negative factor affecting PLIF outcome, although this relationship has not been well studied. In addition, the impact of GJL on adjacent segment pathology (ASP) after PLIF has not been reported. ⋯ Generalized joint laxity at baseline does not impact fusion rate or clinical outcome with respect to pain intensity or functional status but could negatively impact ASP compared with that in patients without GJL. Consequently, GJL should be evaluated preoperatively, and patients with GJL undergoing PLIF should be informed of the potential risks of surgery.
-
Reconstructive surgeries at the occipitocervical (OC) junction have been studied in treating degenerative conditions. There is a paucity of data for optimal fixation for a traumatically unstable OC joint. In clinical OC dislocations, segmental fixation may be impossible because of vertebral artery injury or fracture. Segmental fixation of the occiput, C1, and C2 demonstrated maximum biomechanical stability in fixation of an unstable craniocervical dislocation. A biomechanical study comparing various points of cervical posterior screw fixation after recreating traumatic injury would illuminate relative advantages between the various techniques. ⋯ All fixation constructs significantly reduced motion in all loading modes and CC translations, compared with intact and injury. The construct with the greatest stability against craniocervical dislocation included SPF with instrumentation at the occiput, C1, and C2. By skipping C1 using the EPF, FE and cephalad-caudal translations significantly increased compared with posterior fixation at every level. The addition of a cross-connector increased the stability but was not statistically significant.