-
Thrombosis research · May 2021
Suggestions for global coagulation assays for the assessment of COVID-19 associated hypercoagulability.
- Tom W van de Berg, Anne-Marije M Hulshof, Magdolna Nagy, Rene van Oerle, Jan-Willem Sels, Bas van Bussel, Ten CateHugoHDepartment of Internal Medicine, Cardiovascular Research Institute Maastricht (CARIM), Maastricht University, the Netherlands., Yvonne Henskens, SpronkHenri M HHMHDepartment of Biochemistry, Cardiovascular Research Institute Maastricht (CARIM), Maastricht University, the Netherlands; Central Diagnostic Laboratory, Maastricht University Medical Center+, the Netherlands. Electronic address: henri.sp, and Dutch Covid-19 and Thrombosis Coalition (DCTC).
- Department of Biochemistry, Cardiovascular Research Institute Maastricht (CARIM), Maastricht University, the Netherlands.
- Thromb. Res. 2021 May 1; 201: 84-89.
IntroductionSevere acute respiratory syndrome coronavirus 2 (SARS-CoV2) infection is associated with a clear prothrombotic phenotype. Although the exact pathophysiological mechanisms are not yet fully understood, thrombosis is clearly a highly important in the prognosis and outcome of COVID-19. As such, there is a need for diagnostic analysis and quantification of the coagulation potential in these patients, both at diagnosis and follow-up. Global coagulation assays like thrombin generation (TG) and rotational thromboelastometry (ROTEM) might be suitable in estimating COVID-19 associated coagulopathy and thrombosis risk. Therefore, we aimed at validating both assays for samples with high levels of fibrinogen and in the presence of anticoagulant heparins, such as commonly observed for COVID-19 ICU patients.Materials And MethodsCalibrated Automated Thrombography (CAT) was optimized to assess plasma thrombin generation in the presence of heparins. The final conditions with either 10 μg/mL Ellagic acid (EA) or PPP Reagent HIGH (high tissue factor; HPPH) were validated according to the EP5 protocol for within-run and between-run variability. Overall variability was well below 10%. To estimate the influences of heparins and high fibrinogen levels, CAT was performed on spiked plasma aliquots from 13 healthy volunteers. Comparable to the CAT method, tPA-ROTEM was used to validate the effect of high fibrinogen and heparins on clotting time, clot firmness and clot lysis parameters.ResultsOur adjusted COVID-19 assay showed a heparin dose dependent decrease in peak height and endogenous thrombin potential (ETP) for both EA and HPPH triggered variants. High fibrinogen did not alter the inhibitory effect of either LMWH or UFH, nor did it influence the peak height or ETP in any of the conditions. The tPA-ROTEM showed a significant prolongation in clotting time with the additions of heparin, which normalized with the addition of high fibrinogen. MCF was markedly increased in all hyperfibrinogenemic conditions. A trend towards increased lysis time and, thus, decreased fibrinolysis was observed.ConclusionThrombin generation and tPA-ROTEM protocols for measurements in the COVID-19 populations were adjusted and validated. The adjusted thrombin generation assay shows good sensitivity for measurements in heparin spiked plasma. High levels of fibrinogen did not alter the assay or the effectiveness of heparins as measured in this assay. t-PA ROTEM was effective in measurement of both high fibrinogen and heparins spiked samples and was sensitive to the expected relevant coagulant changes by these conditions. No clear fibrinolytic effect was observed in different conditions.Copyright © 2021 The Author(s). Published by Elsevier Ltd.. All rights reserved.
Notes
Knowledge, pearl, summary or comment to share?You can also include formatting, links, images and footnotes in your notes
- Simple formatting can be added to notes, such as
*italics*
,_underline_
or**bold**
. - Superscript can be denoted by
<sup>text</sup>
and subscript<sub>text</sub>
. - Numbered or bulleted lists can be created using either numbered lines
1. 2. 3.
, hyphens-
or asterisks*
. - Links can be included with:
[my link to pubmed](http://pubmed.com)
- Images can be included with:
![alt text](https://bestmedicaljournal.com/study_graph.jpg "Image Title Text")
- For footnotes use
[^1](This is a footnote.)
inline. - Or use an inline reference
[^1]
to refer to a longer footnote elseweher in the document[^1]: This is a long footnote.
.