• Ruth Shaylor, Eran Golden, Vladimir Verenkin, Marina Kolodii, Michael Peer, Solomon Dadia, Idit Matot, and Barak Cohen.
• Division of Anesthesia, Intensive Care, and Pain Management, Tel Aviv Medical Center, Tel Aviv University, 6 Weizmann St, Tel Aviv, Israel. ruthsha@tlvmc.gov.il.
• Can J Anaesth. 2023 Sep 1; 70 (9): 143314401433-1440.

PurposeAnatomically correct patient-specific models made from medical imaging can be printed on a three-dimensional (3D) printer or turned into a virtual reality (VR) program. Until recently, use in anesthesia has been limited. In 2019, the anesthesia department at Tel Aviv Medical Center launched a 3D program with the aim of using 3D modelling to assist in preoperative anesthesia planning.MethodsA retrospective review of all relevant patients between July 2019 and June 2021 referred for preoperative airway planning with 3D modelling. Patient files were reviewed for correlation between the model-based airway plan and the actual airway plan, the type of model used, and any anesthetic complications related to airway management.ResultsTwenty patients were referred for 3D modelling. Of these, 15 models were printed, including 12 children requiring one lung ventilation. Five patients had VR reconstructions, including three with mediastinal masses. One patient had both a 3D-printed model and a VR reconstruction. There were two cases (10%) where the model plan did not correlate with the final airway plan and one case where a model could not be created because of poor underlying imaging. For the remaining 17 cases, the plan devised on the model matched the final airway plan. There were no anesthetic complications.ConclusionsThree-dimensional modelling and subsequent printing or VR reconstruction are feasible in clinical anesthesia. Its routine use for patients with challenging airway anatomy correlated well with the final clinical outcome in most cases. High-quality imaging is essential.© 2023. Canadian Anesthesiologists' Society.

12 keywords...

hide…