• Soňa Tkáčiková and Ján Sabo.
• Department of Medical and Clinical Biophysics, Faculty of Medicine, Pavol Jozef Šafárik University in Košice, Trieda SNP 1, 040 11 Košice, Slovakia.
• Medicina (Kaunas). 2023 Jun 26; 59 (7).

AbstractBackground and Objectives: The objective of this study was (1) to measure the amount of monomers released into the saliva depending on the time elapsed after the hardening of the composite and on the type of monomer used; and (2) with the prolongation of the light-curing procedure, to publish information on whether it would be possible to influence the level of leached monomers. Materials and Methods: HPLC technique was used to monitor the levels of the unpolymerized monomers Bis-GMA, Bis/EMA, TEGDMA, and UDMA from the four commonly used composite materials, released into the saliva of a volunteer with intact dentition. The levels were monitored in 3 time periods during 24 h after composite hardening. From every composite material, 4 samples were formed and cured with an LED lamp for 10 s, 20 s, 40 s, and 60 s. After the light curing, the same polishing procedure was used and the samples were leached in blank saliva samples. Results: We observed that every monitored composite material eluted monomers into the saliva after its application. The amount of monomers depended on the time elapsed after the curing of the composite and on the type of composite used. A 40 s LED curing procedure can reduce the amount of leached monomers in comparison with the standard 20 s procedure, especially for monomers of higher molecular weight. Conclusions: Our study confirmed the hypothesis that the release of monomers gradually decreases with increasing time after the hardening of the composite filling.

14 keywords...

hide…