• Vincent Arlet, Jeffrey Shilt, and Jean Ouellet.
• Department of Orthopaedic Surgery, University of Virginia, 400 Ray Hunt Drive, Charlottesville, VA 22908, USA. Va3e@hscmail.mcc.virginia.edu
• Eur Spine J. 2005 Oct 1; 14 (8): 789794789-94.

AbstractProximal screw pullout is a well-recognized problem in anterior scoliosis surgery, with a rate of pseudarthrosis or screw pullout ranging from 15 to 30%. To prevent screw pullout at the top of the construct, the authors have devised the concept of a claw for the top instrumented vertebra. The claw consists of a classic anterior vertebral body screw inserted parallel to the inferior end-plate and in the posterior portion of the vertebral body 8 mm in front of the spine canal. After rib desarticulation, a laminar hook of a small size is inserted over the superior aspect of the pedicle of the same vertebra. The rod is then inserted into the two side openings of the screw and the hook. Compression across the hook and the screw is then performed, making a claw construct. This concept can also be extended in the case of early revision for a proximal screw pullout, where it is possible to revise the instrumentation with an offset connector linking the rod to the superior portion of the pedicle where the suprapedicule hook has been inserted. We report two cases where a suprapedicle claw was successfully used in anterior scoliosis correction of a right thoracic curve. Such a concept may represent the solution to proximal screw pullout in anterior scoliosis correction.

12 keywords...

hide…