• Mark Lenz, Dieter Wahl, Boyko Gueorguiev, Jesse B Jupiter, and Stephan Marcel Perren.
• AO Research Institute Davos, Clavadelerstrasse 8, 7270, Davos, Switzerland.
• J. Orthop. Res. 2015 Jul 1; 33 (7): 988-92.

AbstractApplications for fracture-adapted screw positioning offered by variable angle locking screws are increasing. The locking strength of the variable angle locking mechanism at different insertion angles was compared to conventional fixed angle locking screws. Stainless steel (S) and titanium (Ti) variable and fixed angle 2.4 mm locking screws, inserted at different inclinations (0°-15°), and locked at 0.8 Nm were subjected to a load-to-failure test. Ultimate failure moment at the screw-head interface and failure mode of the screws were determined. Significant differences were detected by one-way ANOVA (p < 0.05). Stainless steel and titanium variable angle locking screws inserted at 2°-10° inclination exhibited a failure moment comparable to the 0° position (S 1.67± 0.04 Nm; Ti 1.67 ± 0.14 Nm) and failed predominantly at the screw neck, with the head remaining fixed to the plate. Inserted at 15° inclination, screws revealed a lower failure moment (S 1.33 ± 0.06 Nm, Ti 1.58 ± 0.05Nm), and failed predominantly by breakout of the head thread. Fixed angle locking screws inserted at an inclination >2° did not lock properly in the plate hole, providing insufficient locking strength. Variable angle locking screws offer a stable head-locking mechanism at different inclinations, comparable to the locking strength of orthogonal inserted fixed angle locking screws. Marginal inclinations >15° should be used with care.© 2015 Orthopaedic Research Society. Published by Wiley Periodicals, Inc.

2 keywords...

hide…