• Spine J · May 2017

    T9 versus T10 as the upper instrumented vertebra for correction of adult deformity-rationale and recommendations.

    • Department of Orthopedic Surgery, National University Health System, Singapore. Electronic address: dennis_hey@nuhs.edu.sg.
    • Spine J. 2017 May 1; 17 (5): 615-621.

    Background ContextAdult spinal deformity correction sometimes involves long posterior pedicle screw constructs extending from the lumbosacral spine to the thoracic vertebra. As fusion obliterates motion and places supraphysiological stress on adjacent spinal segments, it is crucial to ascertain the ideal upper instrumented vertebra (UIV) to minimize risk of proximal junctional failure (PJF). The T10 vertebra is often chosen to allow bridging of the thoracolumbar junction into the immobile thoracic vertebrae on the basis that it is the lowest immobile thoracic vertebra strut by the rib cage.PurposeThis study aimed to characterize the range of motion (ROM) of each vertebral segment from T7 to S1 to determine if T10 is truly the lowest immobile thoracic vertebra.Study Design/SettingThis is a prospective, comparative study.Patient SampleSeventy-nine adults (mean age of 45.4 years) presenting with low back pain or lower limb radiculopathy or both, without previous spinal intervention, metastases, fractures, infection, or congenital deformities of the spine, were included in the study.Outcome MeasuresA ROM >5° across two vertebral segments as determined by the Cobb method from radiographs.MethodsLumbar flexion-extension and neutral erect radiographs were obtained in randomized order using a slot scanner. Segmental ROM was measured from T7-T8 to L5-S1 and analyzed for significant differences using t tests. Age, gender, radiographical indices such as standard spinopelvic parameters, sagittal vertical axis (SVA), C7-T12 SVA, T1 slope, thoracic kyphosis (TK), and lumbar lordosis (LL) were studied via multivariate analysis to identify predictive factors for >5° change in ROM at the various segmental levels. There were no sources of funding and no conflicts of interest associated with this study.ResultsIn the thoracolumbar spine, significant decreases in ROM when compared with the adjacent caudad segment occurs up to T9-T10, with mean total ROM of 1.98±1.47° (p<.001) seen in T9-T10, 2.19±1.67° (p<.001) in T10-T11, and 3.92±3.21°(p<.001) in T11-T12. The total ROM of T8-T9 (2.53±1.79°) was not significantly different from that of T9-T10 (p=.261). At the thoracolumbar junction, absence of scoliosis (OR 11.37, p=.020), high pelvic incidence (OR 1.14, p=.046), and low T1 slope (OR 1.45, p=.030) were predictive of ROM >5°.ConclusionsLumbar spine flexion-extension ROM decreases as it approaches the thoracolumbar junction. T10 is indeed the lowest immobile thoracic vertebra strut by the rib cage, and the last significant decrease in ROM is observed at T9-T10, in relation to T10-T11. However, because this also implies that a UIV of T10 would mean there is only one level of fixation above the relatively mobile segment, while respecting other factors that influence UIV selection, we propose the T9 vertebra as a more ideal UIV to fulfill the biomechanical concept of bridge fixation. However, this decision should still be taken on a case-by-case basis.Copyright © 2016 Elsevier Inc. All rights reserved.

      Pubmed     Copy Citation     Plaintext  

      Add institutional full text...

    Notes

     
    Knowledge, pearl, summary or comment to share?
    300 characters remaining
    help        
    You can also include formatting, links, images and footnotes in your notes
    • Simple formatting can be added to notes, such as *italics*, _underline_ or **bold**.
    • Superscript can be denoted by <sup>text</sup> and subscript <sub>text</sub>.
    • Numbered or bulleted lists can be created using either numbered lines 1. 2. 3., hyphens - or asterisks *.
    • Links can be included with: [my link to pubmed](http://pubmed.com)
    • Images can be included with: ![alt text](https://bestmedicaljournal.com/study_graph.jpg "Image Title Text")
    • For footnotes use [^1](This is a footnote.) inline.
    • Or use an inline reference [^1] to refer to a longer footnote elseweher in the document [^1]: This is a long footnote..

    hide…