• Anesthesia and analgesia · Jul 2019

    Comparative Study

    Efficacy of Malignant Hyperthermia Association of the United States-Recommended Methods of Preparation for Malignant Hyperthermia-Susceptible Patients Using Dräger Zeus Anesthesia Workstations and Associated Costs.

    • Victor Manuel Neira, Waleed Al Madhoun, Kamyar Ghaffari, Nicholas Barrowman, Patrick Berrigan, and William Splinter.
    • From the Department of Anesthesiology, Perioperative Medicine and Pain, Dalhousie University, Halifax, Nova Scotia, Canada.
    • Anesth. Analg. 2019 Jul 1; 129 (1): 74-83.

    BackgroundThe objective of this study was to assess the efficacy and cost of Malignant Hyperthermia Association of the United States-recommended methods for preparing Dräger Zeus anesthesia workstations (AWSs) for the malignant hyperthermia-susceptible patient.MethodsWe studied washout profiles of sevoflurane, isoflurane, and desflurane in 3 Zeus AWS following 3 preparation methods. AWS was primed with 1.2 minimum alveolar concentration anesthetic for 2 hours using 2 L/min fresh gas flow, 500 mL tidal volume, and 12/min respiratory rate. Two phases of washout were performed: high flow (10 L/min) until anesthetic concentration was <5 parts per million (ppm) for 20 minutes and then low flow (3 L/min) for 20 minutes to identify the rebound effect. Preparation methods are as follows: method 1 (M1), changing disposables (breathing circuit, soda lime, CO2 line, and water traps); method 2 (M2), M1 plus replacing the breathing system with an autoclaved one; and method 3 (M3), M1 plus mounting 2 activated charcoal filters on respiratory limbs. Primary outcomes are as follows: time to obtain anesthetic concentration <5 ppm in the high-flow phase, peak anesthetic concentrations in the low-flow phase, and for M3 only, peak anesthetic concentration after 70 minutes of low-flow phase, when activated charcoal filters are removed. Secondary outcomes are as follows: cost analysis of time and resources to obtain anesthetic concentration <5 ppm in each method and a vapor-free Zeus AWS. Sensitivity analyses were performed using alternative assumptions regarding the costs and the malignant hyperthermia-susceptible caseload per year.ResultsPrimary outcomes were as follows: M3 instantaneously decreased anesthetic concentration to <1 ppm with minimal impact of low-flow phase. M1 (median, 88 minutes; 95% confidence interval [CI], 69-112 minutes) was greater than M2 (median, 11 minutes; 95% CI, 9-15 minutes). Means of peak rebound anesthetic concentrations in M1, M2, and M3 were 15, 6, and 1 ppm, respectively (P < .001). Anesthetic concentration increased 33-fold (95% CI, 21-50) after removing charcoal filters (from 0.7 to 20 ppm). The choice of anesthetic agents did not impact the results. Secondary outcomes were as follows: M3 was the lowest cost when the cost of lost operating room (OR) time due to washout was included, and M1 was the lowest cost when it was not included. When the cost of lost OR time due to washout was considered the estimated cost/case of M3 was US $360 (M1, US $2670; M2, US $969; and a "vapor-free" Zeus AWS was US $930). The OR time and equipment costs represent the largest differentiators among the methods.ConclusionsInstitutions in which demand for OR time has exceeded capacity should consider M3, and institutions with surplus OR capacity should consider M1.

      Pubmed     Full text   Copy Citation     Plaintext  

      Add institutional full text...

    Notes

     
    Knowledge, pearl, summary or comment to share?
    300 characters remaining
    help        
    You can also include formatting, links, images and footnotes in your notes
    • Simple formatting can be added to notes, such as *italics*, _underline_ or **bold**.
    • Superscript can be denoted by <sup>text</sup> and subscript <sub>text</sub>.
    • Numbered or bulleted lists can be created using either numbered lines 1. 2. 3., hyphens - or asterisks *.
    • Links can be included with: [my link to pubmed](http://pubmed.com)
    • Images can be included with: ![alt text](https://bestmedicaljournal.com/study_graph.jpg "Image Title Text")
    • For footnotes use [^1](This is a footnote.) inline.
    • Or use an inline reference [^1] to refer to a longer footnote elseweher in the document [^1]: This is a long footnote..

    hide…