The Journal of hand surgery
-
To see if locking volar plates approach the strength of dorsal plates on a dorsally comminuted distal radius fracture model. Volar plates have been associated with fewer tendon complications than dorsal plates but are thought to have mechanical disadvantages in dorsally comminuted distal radius fractures. Locking plates may increase construct strength and stiffness. This study compares dorsal and volar locking and nonlocking plates in a dorsally comminuted distal radius fracture model. ⋯ Locking plates failed to increase the stiffness or strength of dorsally comminuted distal radius fractures compared with nonlocking plates. Failure strength and stiffness are greater for locked or nonlocked dorsal constructs than for either locked or nonlocked volar constructs. Whether the lower stiffness and failure strength are of clinical significance is unknown. The unfilled hole at the site of comminution or osteotomy is potentially a site of weakness in both volar locked and nonlocked plates.
-
Randomized Controlled Trial Comparative Study Clinical Trial
A randomized prospective study on the treatment of intra-articular distal radius fractures: open reduction and internal fixation with dorsal plating versus mini open reduction, percutaneous fixation, and external fixation.
To compare 2 methods of surgical treatment for displaced intra-articular fractures of the distal radius: open reduction and internal fixation with dorsal plating (Pi Plate; Synthes, Paoli, PA) versus mini open reduction with percutaneous K-wire and external fixation. ⋯ At midterm analysis the dorsal plate group showed a significantly higher complication rate compared with the external fixator group; therefore enrollment in the study was terminated. The dorsal plate group also showed statistically significant higher levels of pain, weaker grip strength, and longer surgical and tourniquet times. Based on these results we cannot recommend the use of dorsal plates in treating complex intra-articular fractures of the distal radius.
-
This report describes our technique for identifying the spinal accessory nerve during primary exploration of the brachial plexus in infants with obstetric palsy.
-
Radial-sided avulsions of the triangular fibrocartilage complex (TFCC) (Palmer 1D) with distal radioulnar joint (DRUJ) instability remain a challenging pathology to treat. We tested an intra-articular reconstruction that addresses unstable radial-sided TFCC avulsions. ⋯ Current procedures are unable to restore DRUJ stability without a significant limitation of pronation and supination. This intra-articular reconstruction of radial-sided TFCC avulsions succeeded in restoring baseline stability to the DRUJ without interfering with pronation/supination.
-
The ulnar-shortening procedure has been adopted widely to reduce pressure between the ulna and ulnar carpus in ulnocarpal abutment syndrome. The hammock-like structure of the triangular fibrocartilage complex (TFCC), which supports and connects the ulnocarpal and distal radioulnar joint (DRUJ), variably is torn in this condition. The degree to which the torn TFCC may be tensioned to restabilize the DRUJ with ulnar recession is uncertain. This study examined changes in the stabilizing effect of the ulnar-shortening procedure in several TFCC tear conditions. ⋯ The ulnar-shortening procedure can stabilize the DRUJ by increasing intrastructural tension of the TFCC, only when the RUL is attached totally or partially to the ulnar fovea. If the RUL is avulsed completely then stability of the DRUJ no longer is obtained by the ulnar-shortening procedure.