Ergonomics
-
In a national cross-sectional study, the prevalence of neck/shoulder and low-back disorders and their relationship to work tasks and perceived psychosocial job stress was studied among forestry employees. The data were collected by occupational health service staff using Karasek's demand/control questionnaire for the psychosocial measures and the Standardized Nordic questionnaire for the analysis of musculoskeletal disorders. Based on data about past and present work tasks, the study population was classified into three groups: 645 manual workers, 66 machine operators and 124 administrative workers. ⋯ In conclusion, musculoskeletal disorders were associated with both physical and psychosocial work factors. The modest strength of the associations between each individual independent variable and the outcome measure shows, however, that a substantial reduction in the prevalence of musculoskeletal disorders may be difficult to achieve. Nevertheless, the study clearly suggests that in the forestry industry attention should be paid to psychosocial work factors in future organizational changes and preventive programmes.
-
The purpose of the present investigation was to study the overall rating of perceived exertion (RPEov) according to the 6-20 scale proposed by Borg (1970) and muscular RPE (RPEmu) in exercises at constant load. The relationship between RPE and heart rate for three different loads was studied during exhausting exercises in 10 participants. Whether the drift of RPE during a 20 min exercise at constant load could be an index of the endurance time during long-lasting exercises at constant load was also investigated. ⋯ Indeed, the errors in the estimation of exhaustion time from extrapolation of RPE at the beginning of exercise were very large. Moreover, at 60% MAP, a steady-state in RPE was observed during 20 min in five subjects whose tlim were not longer than tlim of the other subjects. In addition, the data of the present study indicate that RPEmu could be more useful than RPEov in cycling.
-
Manual performance while wearing a whole body covering NBC garment was studied at -10 degrees C. Hands were protected by thin cotton gloves, which were covered with rubber gloves. The test subjects were exposed for 40 min in one of the four conditions: standing at -10 degrees C, standing for 10 min followed by walking (5 km/h) for 30 min on a treadmill, standing while holding a solid steel bar (see section 2.2), or standing at 20 degrees C. ⋯ However, only those tasks requiring finger dexterity were clearly adversely affected. Heat production by physical exercise was able to increase finger skin temperature and to partly restore manual performance. Handling of cold tools is especially harmful for the palm side temperature of the non-dominant hand.
-
In ergonomics research, two-dimensional (2-D) biomechanical models are often used to study the mechanical loading of the low back in lifting movements. When lifting movements are asymmetric, errors of unknown size may be introduced in a 2-D analysis. In the current study, an estimation of these errors was made by comparing the outcome of a 2-D analysis to the results of a recently developed and validated 3-D model. ⋯ The results showed a significant underestimation of the peak torque by 20, 36 and 61% when the initial position of a box was rotated 30, 60 and 90 degrees with respect to the sagittal plane of the subject. The main cause of this underestimation was a pelvic twist, resulting in an erroneous projection of a pelvic marker on to the sagittal plane due to pelvic twist. It is suggested that from 30 degrees box rotation a 2-D analysis may easily lead to wrong conclusions when it is used to study asymmetric lifting.