Aaps J
-
Venetoclax (ABT-199/GDC-0199) is a selective, potent, first-in-class BCL-2 inhibitor that restores apoptosis in cancer cells and has demonstrated clinical efficacy in a variety of hematological malignancies. The objective of this analysis was to characterize the population pharmacokinetics of venetoclax and identify demographic, pathophysiologic, and treatment factors that influence its pharmacokinetics. Plasma concentration samples from 505 subjects enrolled in 8 clinical studies were analyzed using non-linear mixed-effects modeling. ⋯ Mild and moderate renal and hepatic impairment, body weight, age, race, weak CYP3A inhibitors and inducers as well as OATP1B1 transporter phenotype and P-gp, BCRP, and OATP1B1/OATP1B3 modulators had no impact on venetoclax pharmacokinetics. Venetoclax showed minimal accumulation with accumulation ratio of 1.30-1.44. In conclusion, the concomitant administration of moderate and strong CYP3A inhibitors and rituximab as well as food were the main factors impacting venetoclax pharmacokinetics, while patient characteristics had only minimal impact.
-
Aerosolisation performance of hygroscopic particles of colistin could be compromised at elevated humidity due to increased capillary forces. Co-spray drying colistin with a hydrophobic drug is known to provide a protective coating on the composite particle surfaces against moisture-induced reduction in aerosolisation performance; however, the effects of component ratio on surface coating quality and powder aerosolisation at elevated relative humidities are unknown. In this study, we have systematically examined the effects of mass ratio of hydrophobic azithromycin on surface coating quality and aerosolisation performance of the co-spray dried composite particles. ⋯ XPS and ToF-SIMS measurements also revealed that 50% by weight (or 35% by molecular fraction) of azithromycin in the formulation provided a near complete coating of 96.5% (molar fraction) on the composite particle surface, which is sufficient to prevent moisture-induced reduction in fine particle fraction (FPF)recovered and FPFemitted. Higher azithromycin content did not increase coating coverage, while contents of azithromycin lower than 20% w/w did not totally prevent the negative effects of humidity on aerosolisation performance. This study has highlighted that a critical amount of azithromycin is required to sufficiently coat the colistin particles for short-term protection against moisture.