• T Yoshikawa and M Arakawa.
• Department of Cariology and Operative Dentistry, Division of Oral Health Sciences, Graduate School of Medical and Dental Sciences, Tokyo Medical and Dental University (TMDU), Yushima, Bunkyo-ku, Tokyo, Japan.
• Niger J Clin Pract. 2022 Mar 1; 25 (3): 255-260.

Aims And BackgroundThis study evaluated the effect of C-factor on the bond strength of a resin composite to floor and wall dentin using various adhesive systems.Materials And MethodsFour dentin substrates (flat wall, flat floor, cavity wall, or cavity floor) were prepared on human molars. Each specimen was restored with one of three adhesives; Clearfil SE Bond, Single Bond, or Clearfil tri-S Bond followed by buildup or filling using Z100 resin composite. The specimen was cut perpendicular to the bonded surface parallel to the floor or wall to obtain beams after light curing at 24,000 mJ/cm2. The microtensile bond strength to wall specimens or the cavity floor was determined. Data were analyzed.ResultsAll adhesive systems exhibited the highest bond strength to flat wall group (p < 0.05). The bond strength to the cavity group was significantly lower than that to the respective flat group regardless of the bonding system (p < 0.05). There was no significant difference in bond strength with Clearfil SE Bond and Clearfil tri-S Bond between the cavity wall and cavity floor (p > 0.05).ConclusionThe findings suggested that the strength of bonding to the cavity floor and cavity wall was affected by C-factor regardless of the adhesive system. Bonding to flat wall was higher than flat floor regardless of the adhesive system. Self-etching system provided uniform bond to the cavity wall and cavity floor dentin. However, total etching system reduced bond to the cavity floor than to the cavity wall.

7 keywords...

hide…