• H Y Gonder and M Fidan.
• Department of Restorative Dentistry, Faculty of Dentistry, Necmettin Erbakan University, Konya, Turkey.
• Niger J Clin Pract. 2022 Oct 1; 25 (10): 1751-1757.

BackgroundPolymerization plays an important role in the optical and mechanical properties resin composite materials.AimThe current study aimed to evaluate the effect of different polymerization times on the color change, translucency parameter (TP), and surface hardness of resin composites after thermocycling.Materials And MethodsMicrohybrid resin composite (Filtek Z250; used in the control group) and bulk-fill resin composites (Filtek One Bulk-Fill Restorative, Tetric EvoCeram Bulk-Fill, and Tetric N-Ceram Bulk-Fill) were used. Each bulk-fill composite was placed as a single layer. Polymerization of the bulk-fill composites in the first group was completed in 20 s, and that in the second group was completed in 40 s (n = 10). Filtek Z250's polymerization was completed with 2 mm (20 s) + 2 mm (20 s). The color change (ΔE00) and translucency parameter (TP00) were calculated using the CIEDE2000 formula. Before and after thermocycling, the TP and surface hardness values were measured. The data were analyzed using one- and two-way analysis of variance, paired-samples t-test, and Tukey's test (P < 0.05).ResultsAfter thermocycling, the ΔE00 values of the resin composite samples were 1.66-2.56. Compared to the control group, the Filtek One Bulk-Fill 20 s group exhibited the lowest color change values. The Filtek Z250 group exhibited lower TP and significantly higher microhardness values than the other bulk-fill resin groups before and after thermocycling (P < 0.05). There were no observed differences in the Tetric N-Ceram and Tetric EvoCeram groups before and after thermocycling.ConclusionUnder the conditions of 10,000 thermal cycles, different curing times did not affect the color change and hardness values of the bulk-fill materials. However, differences were observed among the composite materials. After thermocycling, the surface hardness and TP values decreased in all the resin composites. Depending on the material content, effective results can be obtained from the 20 s polymerization of bulk-fill resin composites.

9 keywords...

hide…