• J A Verschakelen, L Van fraeyenhoven, G Laureys, M Demedts, and A L Baert.
• Department of Radiology, University Hospitals, K. U. Leuven, Belgium.
• AJR Am J Roentgenol. 1993 Oct 1;161(4):713-7.

ObjectiveLung tissue, blood, and air determine the physical density of the lung and hence the attenuation measured on CT scans. These components are not homogeneously distributed throughout the lungs, and their relative proportion changes continuously during respiration. The objective of this study was to measure densities in various areas of the normal lung with CT and to examine the influences of gravity and of the degree of lung inflation on these densities.Subjects And MethodsThe subjects in the study were six healthy male volunteers. CT scans were obtained at the level of the aortic arch and 2 cm above the expiratory level of the diaphragm with the subjects supine and then with them prone. Scans were obtained at lung volumes of 10%, 50%, and 90% vital capacity by using a respiratory gating device connected to the CT scanner. The overall density of the lungs at these two levels and the densities in the dependent (posterior in supine, and anterior in prone body position) and nondependent (anterior in supine and posterior in prone body position) areas were measured by using a semiautomatic evaluation algorithm.ResultsChanges in lung volume caused the same changes in lung density in the right and left lungs and in the upper and lower parts of the lungs. For both body positions (supine and prone), the difference between lung density at 10% vital capacity and that at 90% vital capacity was significantly larger (p < .05) in the dependent parts of the lung than in the nondependent parts. In both positions, differences in density between dependent and nondependent regions were significantly (p < .05) greater at 10% vital capacity than at 90% vital capacity, and the differences became small when the volume of the lung was near total lung capacity.ConclusionChanges in lung volume have different effects on changes in lung density in dependent and nondependent parts of the lung. The largest changes in lung density occur in the dependent regions. The difference in density between dependent and nondependent lung regions is smallest for lung volumes near total lung capacity. These findings may be useful as a baseline for interpreting CT measurements of regional lung density in suspected cases of lung disease, which would alter the physical density of lung tissue. Our results also suggest that measurements near total lung capacity should be included.

13 keywords...

hide…